Minor releases | 810 - xxx
Release 870 | March 2025
Functionalities for Agilent 6495D added
- Export worklist to MS
- Intensity threshold in Settings > Quantification > Intensity threshold
- The "intensity threshold" is used in Quantification > Evaluation > Saturation
Release 864 | February 2025
General performance improvements and bug fixes
Release 842 | February 2025
Load results
Fixed issue: Notes linked with a plate run may have caused an error message.
General performance improvements and bug fixes
Release 840 | January 2025
Export worklist to MS | Support of additional autosampler models
Newly supported autosampler models for SCIEX OS.
| Autosampler model | Rack type | Plate type |
|---|---|---|
| Agilent Infinity II - 3 | Multisampler 2H 2H 2H 2H 5Ref | 96DeepNunc31mm |
| Agilent Infinity II - 4 | Multisampler 2H 2B 2B 2B 5Ref | 96DeepNunc31mm |
| Agilent Infinity II - 5 | Multisampler 2B 2B 2B 2B 5Ref | 96DeepNunc31mm |
| Shimadzu Nexera 40 D | SIL-40 Drawer | Deep Well 96 |
For more information refer to section Export worklist to MS.
Quantification > Evaluation | Issue with "ratio-based" value types
Fixed issues:
- After validation, values of "ratio-based" value types were displayed as "NA".
- Error after changing a value type, e.g. from "Concentration" to "Area ratio".
Quantification > Evaluation | Values after re-integration Fixed issue: After excluding a peak from integration and performing a re-integration, the corresponding values were still displayed.
LIMS > Project | Export worklist to MS
Fixed issue: If a project name contained a comma, an error was shown.
General performance improvements and bug fixes
Release 810 | January 2025
Browser version check
- A browser version check was implemented.
- WebIDQ can exclusively been used with supported web browser versions.
Results | Values when a peak was excluded from integration
- In Quantification > Integration peaks can be excluded from integration, Peak integration options > Remove integration window .
- If a peak was excluded from integration and for values different from "concentration", see Value type, values may have been displayed. However, values should not have been shown, as no integration was performed.
- This issue was fixed.
General performance improvements and bug fixes
Concentration values were always calculated and shown correctly.